Hi, I have problems with a WS-SVC-IPSEC-1 where I'm trying to setup a site-to-site tunnel.
Last night, I got the tunnel up. But after applying a acl to the 6500, the tunnel went down and stayed down. Removing configuration just to get the tunnel up again and continue trying to get the interesting traffic through as intended, the tunnel never comes up. The remote device is a ASA 5505, where I haven't touched anything since this failure started. From what I can get out of all this, looking at logs and crypto statistics. The traffic never gets to the module in slot 8. show crypto sessions - nothing show crypto isakmp sa - nothing show crypto ipsec sa - nothing I can still use packet-tracer on the asa as I could before and the flow is created, but nothing ends up in the 6500 logs. debug crypto isakmp and debug crypto ipsec is both enabled without anything being logged. Any ideas are most welcome. Guess I have missed something obvious but right now I just can't figure out what it is. This it the configuration from the 6500. crypto isakmp policy 1 encr 3des authentication pre-share group 2 crypto isakmp key <SECRETKEY> address <peer ip> no-xauth ! crypto isakmp client configuration group GROUP1 key <KEY> dns 172.16.9.2 domain i.company.com pool vpn acl 101 crypto isakmp profile ikepro match identity group GROUP1 client authentication list userlist isakmp authorization list grouplist client configuration address respond client configuration group GROUP1 crypto isakmp profile site-to-site keyring default match identity address <peer ip> 255.255.255.255 keepalive 60 retry 5 ! ! crypto ipsec transform-set 3dessha esp-3des esp-sha-hmac ! crypto ipsec profile ipsecpro set transform-set 3dessha ! ! crypto dynamic-map dynmap 10 set transform-set 3dessha set isakmp-profile ikepro crypto dynamic-map dynmap 15 set peer 76.238.146.205 set transform-set 3dessha set isakmp-profile site-to-site crypto dynamic-map dynmap 20 set transform-set 3dessha set isakmp-profile ikepro ! ! crypto map vpnmap engine slot 8 crypto map vpnmap 10 ipsec-isakmp dynamic dynmap and then on VLAN 8 where the traffic is suppose to come in: interface Vlan8 ip address <ip> 255.255.255.248 ip nat outside standby 8 ip <standby ip> standby 8 priority 115 standby 8 preempt standby 8 name <standby name> crypto map vpnmap redundancy <standby name> end Best regards, .pelle _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/