On Thu, Dec 17, 2009 at 08:40:10AM -0500, Lobo wrote:
> Hi Peter. The reason why the radio only works at less than 100M is
> because that's all the bandwidth it has. This is licensed based
> wireless technology for point to point shots between buildings.
> Bandwidths can be anywhere from 18M to 400M depending on which frequency
> you use and radio brand. For that 400M radio we use Gig interfaces so
> we would need to use the bandwidth limit command to make sure that it
> only operates at 40% vs 100%.
>
> So for the 2950s and 3550s it looks like we may not have much wiggle
> room. My recommendation might be to upgrade those all to 3750s. :)
In fact a properly implemented sub-rate service should use ethernet
flowcontrol to signal real available bandwidth to the switch.
With flowcontrol working, no such tweaks are necessary.
With kind regards,
M.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
