>> From: Mikael Abrahamsson <[email protected]> > > If you set "ip mtu 1500" then indeed it will not send any IP packets > larger than 1500, and since OSPF runs over IP, this is also affected. > > But yes, you're doing the right thing (if the "mtu 1530" command is > because you're running MPLS or something else non-IP that needs a higher > MTU).
Excellent, this is what I was hoping to hear. And yes, this is a part of our MPLS preparation. >> From: Reuben Farrelly <[email protected]> > > And don't forget - just in case this applies to you: > > ip mtu 1500 > > does NOT apply to IPv6, you'll need to -explicitly- set "ipv6 mtu 1500" as > well :-) > > Reuben > (who recently found this out the hard way with IPv6 OSPF) Thanks for the tip, I hadn't thought that far ahead and likely would have been in the same boat. --Chris _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
