Hi, we have a frame-relay switch that is no longer working. we have 28 t1s on a channelized T3. I was wondering if anyone knows how and if it's possible to terminate frame lines on a cisco, either a 7200 or 6500 without a frame switch.
I followed the example here, http://www.ciscopress.com/articles/article.asp?p=170741 <http://www.ciscopress.com/articles/article.asp?p=170741&seqNum=7> &seqNum=7 but this will not work for me as it assumes you have 2 different frame-relay circuits on two different t1 ports. I'm using a PA MC T# canrd and I also tried creating sub interfaces off the t1 channel, but when I use the frame-relay route command I gives me an error that both DLCIs are on the same interface L. All I'm trying to do is terminate a frame-relay on a cisco without a frame-relay switch. if this possible could someone give me an example or point me in that direction. thanks! paul _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
