I have errors in a ge interface. The error count is the same for input, ignored and rx_resource_error
there are no overrun errors and have: Input queue: 0/75/3/0 (size/max/drops/flushes); Total output drops: 0 Any ideas what might cause this and how to resolve? See below: lax_router7206_2#sh ver Cisco IOS Software, 7200 Software (C7200P-ADVENTERPRISEK9-M), Version 12.4(15)T11, RELEASE SOFTWARE (fc2) Cisco 7206VXR (NPE-G2) processor (revision A) with 1966080K/65536K bytes of memory. Processor board ID 31781651 MPC7448 CPU at 1666Mhz, Implementation 0, Rev 2.2 6 slot VXR midplane, Version 2.7 Last reset from power-on PCI bus mb1 (Slots 1, 3 and 5) has a capacity of 600 bandwidth points. Current configuration on bus mb1 has a total of 0 bandwidth points. This configuration is within the PCI bus capacity and is supported. PCI bus mb2 (Slots 2, 4 and 6) has a capacity of 600 bandwidth points. Current configuration on bus mb2 has a total of 0 bandwidth points. This configuration is within the PCI bus capacity and is supported. Please refer to the following document "Cisco 7200 Series Port Adaptor Hardware Configuration Guidelines" on Cisco.com <http://www.cisco.com> for c7200 bandwidth points oversubscription and usage guidelines. 1 FastEthernet interface 3 Gigabit Ethernet interfaces 4 Serial interfaces 4 Channelized T1/PRI ports 2045K bytes of NVRAM. 250880K bytes of ATA PCMCIA card at slot 2 (Sector size 512 bytes). 65536K bytes of Flash internal SIMM (Sector size 512K). >sh int gigabitethernet 0/3 GigabitEthernet0/3 is up, line protocol is up Hardware is MV64460 Internal MAC, address is 0011.20a5.a019 (bia 0011.20a5.a019) Description: Primary LAN Interface Internet address is 10.0.5.1/24 MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Full-duplex, 1000Mb/s, link type is force-up, media type is SX output flow-control is XON, input flow-control is unsupported ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:01, output 00:00:00, output hang never Last clearing of "show interface" counters 01:42:58 Input queue: 0/75/3/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/max) 5 minute input rate 4116000 bits/sec, 3718 packets/sec 5 minute output rate 4106000 bits/sec, 3393 packets/sec 32370673 packets input, 3809839544 bytes, 0 no buffer Received 4204 broadcasts, 0 runts, 0 giants, 0 throttles 236 input errors, 0 CRC, 0 frame, 0 overrun, 236 ignored 0 watchdog, 4428 multicast, 0 pause input 0 input packets with dribble condition detected 26599809 packets output, 3642106327 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 unknown protocol drops 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier, 0 pause output 0 output buffer failures, 0 output buffers swapped out show controllers: Internal Driver Information: RX Ring base: 0xD7FC6000 TX Ring base: 0xD7FC7000 Software RX Head: 0xD7FC6540 Hardware RX Head: 0xD7FC6DA0 Software TX Head: 0xD7FC8960 Hardware TX Head: 0xD7FC8980 ring sizes: RX = 128, TX = 256 rx_particle_size: 512 rx_pak = 0x06762BF8 rx_head = 42 rx_discard = FALSE tx_head = 203, tx_count = 0 chip_state = 2, ds->tx_limited = 0 throttled = 0, enabled = 0, disabled = 13 reset=6(init=1, restart=5), auto_restart=6 tx_underflow = 0, tx_overflow = 0, tx_end_count = 50636739 rx_nobuffer = 0, rx_overrun = 0 rx_no_descriptors = 0, rx_interrupt_count = 19562530 rx_crc_error = 0, rx_too_big = 0, rx_resource_error = 236 rx_sop_eop_error = 0 tqc = 0xF1002C48, cause = 0xF1002C60, cause_ext = 0xF1002C64 Address Filter: Promiscuous mode OFF (All other entries are empty) _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
