On (2010-02-09 13:56 +0100), Andy B. wrote: > I think I am not software switching: > > CPU utilization for five seconds: 19%/5%; one minute: 46%; five minutes: 42%
Could you try to catch this when the five second value is >40% so we'll see what is causing the load. Currently what ever is happening, is not happening. Output 5s sorted list. > Module pps peak-pps peak-time > 5 4443376 10849623 12:44:28 CEST Mon Dec 21 > 2009 10Mpps peak, well within limits of CFC system, so you're not anywhere near the performance limits. > Netflow Resources > TCAM utilization: Module Created Failed %Used > 5 262020 0 100% Netflow full, highly typical and nothing to worry about. > I do see input drops - what does that mean? It means that you got more packets towards software than buffers could hold, default is 75 packets, which is way too little for even some normal situations, such as BGP, especially route reflector use. If it is normal, you should increase it to 1k or 2k. But it might also indicate that transit traffic is coming to control-plane, there are many tools 7600 offers to troubleshoot them. When you look at those interfaces where you see drops, do any of them display packets in input buffer /right now/, if so, you can use 'show buffers input-interface X header' to see those packets are, which will go long way to determine if they are normal or something to worry about. -- ++ytti _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
