Try with the following ip access-list extended IP-All permit ip any any [MATCH PREFIXES YOU WANT]
Class-map match-all IP-All match access-group name IP-All Policy-map RATE class IP-All police cir 2096000 bc 128000 be 128000 conform-action set-dscp-transmit default exceed-action drop violate-action drop int [Name] service-policy input RATE Service-policy output RATE Regards, Salman Zahid On Thu, Feb 11, 2010 at 6:10 AM, Leslie Meade <[email protected]> wrote: > While I would of agreed with you comment, why is it that I am able to put > the rate limit commands on failover 6509 ? > > > -----Original Message----- > From: Asbjorn Hojmark - Lists [mailto:[email protected]] > Sent: Wednesday, February 10, 2010 3:08 PM > To: Leslie Meade > Cc: [email protected] > Subject: Re: [c-nsp] rate-limit command not accepting ? > > On Wed, 10 Feb 2010 11:00:55 -0800, you wrote: > > > DTCCAT-CORE01(config-if)# rate-limit input 2096000 128000 128000 > conform-action transmit exceed-action drop > > ^ > > % Invalid input detected at '^' marker. > > The rate-limit command is not supported on Catalyst 6500. > Use a policy-map with policing instead. > > -A > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > -- You only live once, but if you work it right, once is enough...... _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
