Sorry the last line should be ip address 208.70.109.156 255.255.255.255
Making the secondary primary, and removing the primary. I remember doing it with no ip address x.x.x.x.... but I just tried and it gives me the same error. Too much lunch I think. Brian -----Original Message----- From: Steve Bertrand [mailto:[email protected]] Sent: giovedì 18 febbraio 2010 14.22 To: Brian Turnbow Cc: james edwards; [email protected] Subject: Re: [c-nsp] Renumbering serial interfaces On 2010.02.18 03:22, Brian Turnbow wrote: > Besides the reload in xx that several have mentioned you can also put > secondary Ips on the link > Nad then cancel the primary. > > I.e. > interface ATM0/0.32 point-to-point > Ip add 2.2.2.2 255.255.255.252 secondary > > Telnet/ssh to this address using source address 2.2.2.1 > Then no ip add 1.1.1.1 255.255.255.252 > The 2.2.2.2 address becomes the priamry and you should not loose the > management session. Does this work differently on a serial interface? On an fa int: route-server1(config)#int lo75 route-server1(config-if)#ip address 208.70.109.155 255.255.255.255 route-server1(config-if)#ip address 208.70.109.156 255.255.255.255 sec route-server1(config-if)#no ip address 208.70.109.155 255.255.255.255 Must delete secondary before deleting primary Steve _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
