I have considered that but that would involved re-designing the second hub/rest of the DMVPN cloud so I was hoping there was another solution...
I found a config where you can put each ISP on a VRF and do fancy route redistribution, which could work. It seemed a little too complicated than it should be but that may be where I need to go. On Tue, Mar 2, 2010 at 2:52 PM, Rodney Dunn <[email protected]> wrote: > Most people run dual DMVPN clouds with two tunnels on the spoke. > > One primary cloud for CM and one for the T1 side. > > Your failover comes from the dyanmic routing protocol running over the > clouds (ie: eigrp). > > On the spoke you put a /32 route for the two hub ip's out each respective > internet link. > > Rodney > > > > On 3/1/10 3:08 PM, Jay Nakamura wrote: >> >> All, >> >> I have a site that has a cable modem and a T1. I was able to >> configure internet access redundancy using IP SLA/track. This site is >> also spoke side of a DMVPN mesh. Is there anyway I can make DMVPN to >> failover to the other connection? I can't find any reference to it so >> far. I am not sure what you can do when the tunnel interface for >> DMVPN you have to specify "tunnel source" and that will be different >> depending on which link is up and running. >> >> Thanks, >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
