Well, I downgraded to the latest 12.4 (c7200-is-mz.124-25c.bin). Same
symptoms. Any ideas? I tried removing the port-channel and re-adding
too, no luck.
-Jason
On 4/12/2010 3:30 PM, Jason Berenson wrote:
Greetings,
I just upgraded a Cisco 7206 NPE-400 to:
c7200-advipservicesk9-mz.151-1.XB.bin from the latest 12.4. I've got
a port channel and it removed the 'channel-group 1' line from the two
ethernet interfaces. When I try to add them back I get:
router(config-if)#channel-group 1
Error: This interface does not allow user-settable mtu.
Remove the mtu command from the port channel configuration
to be able to add this interfaceto the port channel
I don't have any mtu commands on any interfaces except the defaults,
which can't be removed. Here's the relevant config:
interface Port-channel1
description << TO GI9/5 10/5 >>
no ip address
no ip redirects
random-detect
!
interface Port-channel1.11
encapsulation dot1Q 11
ip address IP 255.255.255.0
no ip redirects
ip ospf authentication-key 7
ip ospf cost 1
ip ospf dead-interval minimal hello-multiplier 4
!
interface FastEthernet0/0
description << TO 9/5 >>
no ip address
no ip redirects
no ip unreachables
duplex full
random-detect
no cdp enable
!
interface FastEthernet2/0
description << TO 10/5 >>
no ip address
no ip redirects
no ip unreachables
duplex full
no cdp enable
!
Any tips/help would be greatly appreciated.
Thanks,
Jason
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
