Hello, trying to determine if this is is an issue with the line card (WS-X6148-GE-TX) or the chassis (6509). Out of the blue once every 6 months or so we get:
May 25 07:09:55.108 CDT: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 8 is experiencing the following error: Bus Asic #0 out of sync error May 25 07:10:13.107 CDT: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 8 is experiencing the following error: Bus Asic #0 out of sync error ... After ~5 minutes of the above errors the card shuts down: May 25 07:14:59.717 CDT: %LINK-3-UPDOWN: Interface GigabitEthernet8/4, changed state to down May 25 07:14:59.717 CDT: %LINK-3-UPDOWN: Interface GigabitEthernet8/8, changed state to down May 25 07:14:59.717 CDT: %LINK-3-UPDOWN: Interface GigabitEthernet8/10, changed state to down <snip> May 25 07:14:59.921 CDT: %HA_EM-6-LOG: Mandatory.go_intlpbk.tcl: GOLD EEM TCL policy for TestIntPortLoopback May 25 07:14:59.625 CDT: %CONST_DIAG-SP-6-HM_TEST_SP_INFO: TestIntPortLoopback[8]: last_busy_percent[23%], Tx_Rate[68730], Rx_Rate[10475] May 25 07:14:59.625 CDT: %CONST_DIAG-SP-2-HM_MOD_RESET: Resetting Module 8 for software recovery, Reason: Failed TestIntPortLoopback May 25 07:14:59.625 CDT: %OIR-SP-3-PWRCYCLE: Card in module 8, is being power-cycled 'off (Diagnostic Failure)' May 25 07:14:59.761 CDT: %C6KPWR-SP-4-DISABLED: power to module in slot 8 set off (Diagnostic Failure) At this point we have to re-seat the card. Currently running 12.2(33)SXI2a. Trying to determine which (or both) to replace- module or chassis. Thoughts? --Chris _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
