Hi all. Can someone give me a hint on what is pulling my legs. I'm trying to run EoMpls between a vss environment and a std 6500. The module I'm using on the vss is a WS-X6724-SFP nad in the other end I'm using a WS-X6148-GE-TX. The link is a loop between the two local interfaces. I have two other links running between the to routers, and this works fine. When I enable the 3 link the udlnd error disables the one interface, so I was sure that it was a defect module. But the ports works fine when I attach an 3750 switch, and the ports stays up without the udln pulls the link down.
Vss-config interface GigabitEthernet2/2/12 no switchport no ip address xconnect 192.168.101.23 1012332254 encapsulation mpls interface GigabitEthernet2/2/13 switchport switchport access vlan 3899 switchport mode access spanning-tree bpdufilter enable 6500-config interface GigabitEthernet9/39 switchport switchport access vlan 254 switchport mode access no ip address spanning-tree bpdufilter enable interface GigabitEthernet9/40 no ip address xconnect 192.168.101.32 1012332254 encapsulation mpls error-code %UDLD-SW1_SP-4-UDLD_PORT_DISABLED: UDLD disabled interface Gi2/2/13, unidirectional link detected /Arne _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
