Here is a show version from one of our 7200 G2: ATM STM-1 card placed in slot 2 and 3
PCI bus mb1 (Slots 1, 3 and 5) has a capacity of 600 bandwidth points. Current configuration on bus mb1 has a total of 300 bandwidth points. This configuration is within the PCI bus capacity and is supported. PCI bus mb2 (Slots 2, 4 and 6) has a capacity of 600 bandwidth points. Current configuration on bus mb2 has a total of 300 bandwidth points. This configuration is within the PCI bus capacity and is supported. Please refer to the following document "Cisco 7200 Series Port Adaptor Hardware Configuration Guidelines" on Cisco.com <http://www.cisco.com> for c7200 bandwidth points oversubscription and usage guidelines. 1 FastEthernet interface 3 Gigabit Ethernet interfaces 2 ATM interfaces 2045K bytes of NVRAM. 3 STM-1 should be OK, as long as cards are distributed left/right and no other cards in chassis. Jon ________________________________________ Fra: [email protected] [[email protected]] på vegne av RAZAFINDRATSIFA Rivo Tahina [[email protected]] Sendt: 6. juli 2010 08:34 Til: [email protected] Emne: [c-nsp] 7206 and STM-1 Hi all, We plan to use a 7204 NPE-G2 with 3 STM-1 (PA-POS-OC3SMI ), will the 7206 NPE-G2 support 3x155Mbps traffic? Regards. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
