Peter Hicks wrote: > All, > > We have three E1 voice circuits on a 2821 - two from the same provider > on on E1 0/0/0 and E1 0/0/1, and a third from a different provider on a > E1 0/1/0 - a separate VIC. > > After fixing a broken fan on the router, the third E1 is experiencing > slip seconds. The other two are clean, and I suspect this is due to the > router being configure to use the clock from E1 0/0/0. There is no loss > of service, however I'm keen to sort out this problem as it might affect > service in the future. > > How can I resolve the problem? Is it possible to use a different clock > for each VIC?
Unforutnatly it depends on your hardware.. The 2nd gen cards will do it , the first gen cards no. You need to add "independent" at the end of the clock source under the controller. I think the 2nd gens are vwic-2xxx IIRC.... Brian _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
