Hi all,
When startup-config is swapped with TCAM(CEF MAX) size change, RELOAD of two times is needed. It is automatically generated once of RELOAD of two times. Can this behavior be evaded? (I am looking for "Method of reflecting all changes with RELOAD of one time". ) ---------- Catalyst6503E SUP720-3BXL s72033-ipservicesk9_wan-vz.122-33.SXI3 (1)Before startup-config = AAA.txt #show run mls cef maximum-routes ip 1000 #show conf mls cef maximum-routes ip 1000 #show mls cef maximum-routes FIB TCAM maximum routes : ======================= Current :- ------- IPv4 - 1000k MPLS - 8k (default) IPv6 + IP Multicast - 8k (default) (2)SWAP startup-config startup-config = AAA.txt -> BBB.txt #copy disk0:BBB.txt startup-config #show run mls cef maximum-routes ip 1000 #show conf mls cef maximum-routes ip 800 mls cef maximum-routes ipv6 100 (3)1st RELOAD(manual) #reload System configuration has been modified. Save? [yes/no]: no Proceed with reload? [confirm] yes(enter) startup-config = BBB.txt #show run mls cef maximum-routes ip 800 mls cef maximum-routes ipv6 100 #show conf mls cef maximum-routes ip 800 mls cef maximum-routes ipv6 100 #show mls cef maximum-routes FIB TCAM maximum routes : ======================= Current :- ------- IPv4 - 1000k MPLS - 8k (default) IPv6 + IP Multicast - 8k (default) (4)2nd RELOAD(automatic) "Card inserted in slot x, interfaces are now online" is displayed in the log, and RELOAD auto starts again after a few minutes. Of course, I am not operating anything... (5)After startup-config = BBB.txt #show run mls cef maximum-routes ip 800 mls cef maximum-routes ipv6 100 #show conf mls cef maximum-routes ip 800 mls cef maximum-routes ipv6 100 #show mls cef maximum-routes FIB TCAM maximum routes : ======================= Current :- ------- IPv4 - 800k MPLS - 8k (default) IPv6 - 100k IP multicast - 8k (default) <note_1> The above-mentioned value of "TCAM size" is an example, and is not accurate. <note_2> The following procedures... -> NG (It results similarly) a) "TCAM size" change by command (ip 1000 -> ip 800 / ipv6 100) b) startup-config swap (AAA.txt -> BBB.txt) c) reload ---------- Cheers, nakayama daigo _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
