Hello group,
After replacing an apparently faulty power supply, we got these messages:
%POWERMGR-5-REMOVED: PEM1 removed
%POWERMGR-4-UNPOWERED: PEM1 inserted but unpowered
The message means the following:
%POWERMGR-4-UNPOWERED:PEM[dec] inserted but unpowered
Explanation The power supply specified has been installed in the chassis but
is unpowered, most likely because of an unconnected
power cord.
Everything was checked and there is no problem with the cable or the AC power
source.
What could it be ? A problem with the PDU ?
PNs involved: PWR-GSR10-AC-B= and GSR10-AC-PDU-B=.
We found strange this output in the show diag:
PEM 1 (POWER_A ): Intelligent AC PS [PWR-GSR10-AC-B=]
MAIN: type NA, 341-0053-02 rev A0
Deviation:
Design Release 1.0 S/N xxxx
FRU: NAME: PWR-GSR10-AC-B==
PEM 2 (POWER_B ): Intelligent AC PS [PWR-GSR10-AC-B=]
MAIN: type NA, 341-0053-01 rev A0
Deviation:
Design Release 1.0 S/N xxxx
FRU: NAME: PWR-3000-AC=
PEM2 is the good one and PEM1 is the spare we used. The FRU info is wrong in
both cases. It should be PWR-GSR10-AC-B= (just one =
sign in the end).
Thanks.
Regards,
Antonio Soares, CCIE #18473 (R&S/SP)
[email protected]
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
