Have a remote setup w/ASA 5505... essentially setting up a site-to-site tunnel and routing a local inside subnet back to the main campus. (Default inside route part of crypto-map match so all traffic is tunneled).
Everything is working, but I'm less than excited about the 5505s DHCP abilities, would rather have the remote addressing managed by our central server. If I enable "DHCP relay" on the inside interface, it insists that the DHCP server target is "not" on the inside interface. If I direct it to the outside interface, it doesn't go over the tunnel and gets dropped. If I try to specify the relay target on the inside interface, it gives an error that it can't reside on an interface where relay is enabled. I suspect I need an outside route that also tunnels? Anyone have a quick fix or pointer? Jeff _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
