Howdy, I currently have two connections to Level3 because I am upgrading, one (the old one) is a 1Gbps connection in Router-1, the second one is a 10Gbps connection in Router-2.
Both connections are up/up, the old connection is getting a full BGP session from Level3. I noticed that no matter what I do, I can't seem to ping Level3's side of our 10Gbps interface on the new connection from either of the 2 routers rtr#ping ip Target IP address: x.x.x.13 Repeat count [5]: Datagram size [100]: Timeout in seconds [2]: Extended commands [n]: y Source address or interface: x.x.x.14 Type of service [0]: Set DF bit in IP header? [no]: Validate reply data? [no]: Data pattern [0xABCD]: Loose, Strict, Record, Timestamp, Verbose[none]: Sweep range of sizes [n]: Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to x.x.x.13, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) I am able to ping their side of the interface from hosts downstream from the routers, just not the routers themselves. [r...@vmz ~]# ping x.x.x.13 PING x.x.x.13 (x.x.x.13) 56(84) bytes of data. 64 bytes from x.x.x.13: icmp_seq=1 ttl=60 time=3.27 ms 64 bytes from x.x.x.13: icmp_seq=2 ttl=60 time=14.9 ms 64 bytes from x.x.x.13: icmp_seq=3 ttl=60 time=3.01 ms 64 bytes from x.x.x.13: icmp_seq=4 ttl=60 time=3.19 ms 64 bytes from x.x.x.13: icmp_seq=5 ttl=60 time=3.10 ms I can't really think of any reason why I wouldn't be able to ping their end of the Interface from this router, connectivity is obviously good considering I can ping it from a host downstream from the router. Is anyone aware of any sort of gotcha when doing something like this? -Drew _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
