Yes i remember you need a certain license to be able to do failover . You could just try to configure it and if you don;t have the proper license it should say something about that , or just contact your cisco reseller
--- On Sun, 9/12/10, Fourpros it <[email protected]> wrote: From: Fourpros it <[email protected]> Subject: [c-nsp] Cisco ASA 5510 Failover- Active/StandBy To: [email protected] Date: Sunday, September 12, 2010, 2:57 PM Dear experts, I have two Cisco ASA 5510, Model ASA5510-AIP10-K9 and ASA5510-CSC10-K9, now the scenario is to do failover Active/Standby statefull. On the Model Comparison Sheet of CISCO ASA5500 Series, mentioned that For Failover on ASA 5510 required a Security Plus licenses and On Cisco ASA Command Configuration Guide there mentioned Base licenses work required Security Plus license for ASA 5505 only. So in my case is it required to have Security Plus license or not??? Another for failover, both device should be identical but i have two different model device- AIP and CSC. So for this if i remove the module AIP and CSC from the devices will it be working for failover on normal base firewall mode ASA.If there is any other method to fulfill this scenario then please suggest me. Please provide any such procedure that made my Cisco ASA 5510 be used on fail over mode. It will be great help from the experts like you. Thank You Regards, Fourprosit _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
