I've got a 2811 running 12.4(24)T3. I'm trying to set it up as PPPoE client.
Everything works fine when I do this in the global routing table: interface Dialer1 ip address negotiated ip mtu 1492 encapsulation ppp dialer pool 1 dialer-group 1 ppp chap hostname ........... ppp chap password ........... IPCP: I CONFREQ [REQsent] id 1 len 10 IPCP: Address ............. IPCP: O CONFACK [REQsent] id 1 len 10 IPCP: Address ............. IPCP: I CONFNAK [ACKsent] id 1 len 10 IPCP: Address ............. IPCP: O CONFREQ [ACKsent] id 2 len 10 IPCP: Address ............. And I end up with two connected host routes in the routing table. When I try and put the Dialer interface into a VRF the Dialer config changes to: interface Dialer1 ip vrf forwarding VRF_A no ip address ip mtu 1492 encapsulation ppp dialer pool 1 dialer-group 1 ppp chap hostname ............ ppp chap password ............ PPP no longer negotiates an IP address: IPCP: I CONFREQ [Not negotiated] id 1 len 10 IPCP: Address ........... LCP: O PROTREJ [Open] id 2 len 16 protocol IPCP 'ip address negotiated' is accepted on the CLI, but isn't applied, the dialer interface stubbornly retains "no ip address". I've tried 'ppp ipcp accept-address' but it makes no difference. I've googled and found 'Dialer Watch' but it looks like that requires the IP address to be configured in the Dialer rather than negotiated upon connection. I hope I'm missing something obvious. Any ideas? If it's not possible, are there any other alternatives for getting traffic into VRF_A? -Ronan _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
