> > > > Hello, > > I configured my dial-peer in this way: > dial-peer voice 1400 pots > voice cut-through alert > preference 4 > destination-pattern 199151119 > progress_ind setup enable 1 > no digit-strip > port 0/0/1:15 > !
Better to use progress_ind setup enable 3 Telling the network that the originating address is not ISDN. This will tell the remote side "I don't generate tones please do it for me" (more or less:)) You may also add progress_ind alert enable 8 progress_ind progress enable 8 forcing the router to treat the incoming alerts as in band info is now available. > > Now i see the PI reminder: > > Nov 15 14:39:07.121 CET: ISDN Se0/1/0:15 Q931: TX -> SETUP pd = 8 > callref > = 0x1C5C > Bearer Capability i = 0x8090A3 > Standard = CCITT > Transfer Capability = Speech > Transfer Mode = Circuit > Transfer Rate = 64 kbit/s > Channel ID i = 0xA9839F > Exclusive, Channel 31 > Progress Ind i = 0x8181 - Call not end-to-end ISDN, may have in- > band info > > Calling Party Number i = 0x0180, '03631970353' > Plan:ISDN, Type:Unknown > Called Party Number i = 0x81, '199151119' > Plan:ISDN, Type:Unknown > Nov 15 14:39:07.133 CET: ISDN Se0/1/0:15 Q931: RX <- SETUP_ACK pd = 8 > callref = 0x9C5C > Channel ID i = 0xA9839F > Exclusive, Channel 31 > Nov 15 14:39:08.253 CET: ISDN Se0/1/0:15 Q931: RX <- CALL_PROC pd = 8 > callref = 0x9C5C > Here there is still no indicator saying inband info is now available. So the gateway does not open the channel. Ciao Brian > Looking at this: > http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080 > 094c33.shtml#progresstones > I would expect the call to be cutted-throug after the SETUP_ACK has > been > received. > Anyway I have the same problem, no audio i sent to my phone before the > CONNECT message. > > Thank You _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
