Hi
We are facing an issue between a switch Force10 E1200 and our Cisco
equipments:
We tried:
A 2960 Cisco
A 2960G cisco
A 7301 cisco Router
Using copper FE, copper GE and now LX OF
In each case we get 1 to 2% CRC and Input errors:
C7301#sh interface GigabitEthernet0/1
GigabitEthernet0/1 is up, line protocol is up
Hardware is BCM1250 Internal MAC, address is 0018.7410.941a (bia
0018.7410.941a)
MTU 1558 bytes, BW 100000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 1., loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is force-up, media type is LX
output flow-control is unsupported, input flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:27:36
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 127000 bits/sec, 21 packets/sec
5 minute output rate 194000 bits/sec, 181 packets/sec
64843 packets input, 37333016 bytes, 0 no buffer
Received 7313 broadcasts, 0 runts, 0 giants, 0 throttles
124 input errors, 86 CRC, 0 frame, 26 overrun, 0 ignored
0 watchdog, 5088 multicast, 0 pause input
0 input packets with dribble condition detected
306551 packets output, 38459366 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
7301 setup:
interface GigabitEthernet0/1
mtu 1554
no ip address
no ip redirects
duplex full
speed 1000
media-type gbic
no negotiation auto
!
interface GigabitEthernet0/1.4
encapsulation dot1Q 4
ip address xxx xxx
Did anyone face this kind of problems between Force10 and Cisco? On the
Force10 we can't see any errors...
On the force10:
interface GigabitEthernet 12/2
no ip address
switchport
no spanning-tree
no negotiation auto
no shutdown
interface Vlan 4
tagged GigabitEthernet 12/2
--
sh int gi12/2
GigabitEthernet 12/2 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:04:7b:bb
SFP present. Media type is LX.
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 13w1d2h
Queueing strategy: fifo
7837488062 packets input, 9195152796983 bytes
Input 7837050405 IP Packets, 7837482636 Vlans 0 MPLS
10070431 64-byte pkts, 1084598600 over 64-byte pkts, 336859355
over 127-byte pkts
159265709 over 255-byte pkts, 242211863 over 511-byte pkts,
6004482104 over 1023-byte pkts
Received 0 input symbol errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 IP Checksum, 0 overrun, 0 discarded
7742215926 packets output, 1750697618039 bytes, 0 underruns
Output 5226770 Multicasts, 11080696 Broadcasts, 7725908460 Unicasts
7732658981 IP Packets, 7742215926 Vlans, 0 MPLS
0 throttles, 0 discarded
Rate info (interval 5 minutes):
Input 00.84Mbits/sec, 608 packets/sec
Output 02.51Mbits/sec, 376 packets/sec
Time since last interface status change: 08:10:21
Thanks for your help
--
Jerome Schevingt
Ingénieur Systèmes et Réseaux
PHIBEE
Tel: +33(0)426847860
Mobile: +33(0)607759222
Fax: +33(0)426847861
Mail: [email protected]
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
