That is the other thing unsupported without the right cards. :) You either need to use the right cards or use an external loopback cable which basically loops the SVI into a separate P2P interface on the same router.
Phil On 1/12/11 9:28 AM, "Pavel Dimow" <[email protected]> wrote: >Hi, > >I just found out that 7600 does not support VPLS without "correct" >line cards. Now I'am trying to find a solution >how to xconnect SVI on 7600 (physical L3 int works just fine) in >point-to-point. >I tried to use vfi in point-to-point configuration but without success >as I can't find on cisco.com what else should I configure >for this kind of vc. > > >l2 vfi TESTING point-to-point > ! Incomplete point-to-point vfi config > neighbor 10.10.10.10 3000 encapsulation mpls > >Any thoughts? >_______________________________________________ >cisco-nsp mailing list [email protected] >https://puck.nether.net/mailman/listinfo/cisco-nsp >archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
