Cisco 7206 VXR , NPE-G2, (C7200P-ADVIPSERVICESK9-M), Version 12.2(33)SRE1 interface GigabitEthernet0/2.705 encapsulation dot1Q 705 ! interface ATM2/0 pvc 0/38 l2transport encapsulation aal5snap ! connect atm-eth-one ATM2/0 0/38 GigabitEthernet0/1.705 interworking ethernet !
G0/2 port backs into a trunk on my switch where int vlan 705 has an IP address, trunk has vlan 705 allowed. Customer on the other side of the ATM PVC has an ATM-Ethernet bridging NTU from the carrier, FastEthernet plugged into a laptop with an IP. If I reconfigure the ATM to use a normal subif, atm route-bridged and an IP address I can ping the customer end, so I know the PVC and ip addressing is happy. Configuring it as per the above and attempting to ping the customer from my switch with the routed VLAN interface doesn't work - what am I missing in this equation? Thanks Phil P _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
