1.  Do you know if this is all the attributes that a CSS's can route traffic 
based on? From the CSS config guide exert below i.e. L3, L4 and L5
     *   destination IP
     *   destination port
     *   protocol
     *   domain
     *   context path

There are more.

  2.  What about other methods:
     *   source IP
     *   source port
     *   server certificates?
     *   client certificates?
     *   any others?

Yes, there are others. All of them are described and detailed configuration guide(s).

You should start here: http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_installation_and_configuration_guides_list.html

Look for the balance command.

  3.  Do they support SSL client authentication rather than server 
authentication?

Yes.  See the SSL configuration guide from the above main link.
  4.  If 3) is true, do you know how many client certificates can they host?
I do not remember the limitations as it's been a while. It may be in the docs. And, I don't have them up in my lab yet to verify for you.

  5.  Are the load balancers capable of probing a service to determine if there 
are packet delays on a network or a server resource is very high, then make a 
decision based on certain criteria i.e. route traffic to another server or 
network?

Yes. In Ciscoland with CSS, these are called keepalives. See the Load-Balancing configuration guide.
  6.  If a service is configured to forward to tcp port<any>  (not www traffic), http 
keepalive is used and a 200 OK status is not returned, the server (xx) is then assumed down 
and therefore any new traffic is sent to another server in a group.  If server (xx) is not 
actually down just http/443, will any traffic that was established when the load balancer 
saw the (xx) http keepalive go down, continue to flow back via tcp port<any>  to the 
load balancer and to whence it came from?  Or will it be dropped / lost as the load 
balancer will lose any translations?

I'm not sure I'm following your example. Just because a server does not use the standard HTTP port does not mean it works differently on the CSS. You just specify the port for the service and the keepalive.
Sam Hall
Senior Network Engineer


tv
_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

Reply via email to