Hello group, I'm troubleshooting a FSWM Failover issue. The scenario has the two FWSM in different chassis in Active/Active mode.
One chassis went down and the FSWM in the other chassis didn't assume the control of the two failover groups. The only message that was possible to capture was: "FO_LINK Vlan 1998 Failed No switchover" I'm not able to find out in which situations the Vlan could have failed. According to the document bellow (Table 13-2 Failover Behavior for Active/Active Failover), this could be seen as normal behavior: http://www.cisco.com/en/US/docs/security/fwsm/fwsm32/configuration/guide/fai l_f.html#wp1052847 1) Failover link failed during operation-> 2) No failover-> 3) Each unit marks the failover interface as failed. You should restore the failover link as soon as possible because the unit cannot fail over to the standby unit while the failover link is down. My question is how could that FO_LINK VLAN go down ? The FO and STATE VLANs were present on the switch and nobody touched them. The FWSM is running 3.2(7). Thanks. Regards, Antonio Soares, CCIE #18473 (R&S/SP) [email protected] http://www.ccie18473.net _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
