I've been searching Cisco documentation ( and this archive ), and i want to confirm something with respect to 7600 VPLS
The following example shows how to create a Q-in-Q AC, with IOS XR RP/0/RSP0/CPU0:router# configure RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet 0/0/0/0.2 RP/0/RSP0/CPU0:router(config-subif)# l2transport RP/0/RSP0/CPU0:router(config-subif)# encapsulation dot1q 200 second-dot1q 201 RP/0/RSP0/CPU0:router(config-subif)# commit RP/0/RSP0/CPU0:router(config-subif)# exit RP/0/RSP0/CPU0:router(config)# exit It seems to me that the only way to do this is with a 7600 with a ES+ card, and not in a CAT LAN card ( WS6748).. so if a customer needs to do this, they need to migrate their hw and their configuration, from something like this:. l2 vfi name manual vpn id yy neighbor x.x.x.x encapsulation mpls interface GigabitEthernet X/X ( lan card port ) switchport switchport trunk encapsulation dot1q switchport trunk allowed vlan yy switchport mode trunk interface Vlanyy no ip address xconnect vfi name to this: l2 vfi name manual vpn id yy neighbor x.x.x.x encapsulation mpls interface GigabitEthernet X/X ( es+ port ) port-type nni switchport trunk allowed vlan none switchport mode trunk service instance yy ethernet encapsulation dot1q 200 second-dot1q yy bridge-domain yy is that correct? _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
