Is the 6548 card the card in slot 2? I am assuming it is. The card either has a bus issue or is not seated properly. I would try removing the card, check for damage to the connectors, and reseat the card. You may need to do this with the card in slot 2 and any other cards that have been recently added or worked on. If reseating the cards doesn't solve the problem, it probably indicates either the module in slot 2 or the recently added card has an issue. It could also be one of the chassis slots but the card is a more likely culprit.
Mack -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Chris Knipe Sent: Monday, June 06, 2011 11:38 AM To: [email protected] Subject: [c-nsp] WS-X6548-GE-TX Error? Hi All, I have a 6506 and recently installed an WS-X6548-GE-TX into the chassis. The chassis has already rebooted once, and now I am getting errors too from the module: Jun 6 17:11:36 SAST: %ONLINE-SP-6-TIMER: Module 2, Proc. 0. Failed to bring online because of timer event Jun 6 17:11:36 SAST: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set off (Reset) Jun 6 17:11:56 SAST: %C6KERRDETECT-SP-2-SWBUSSTALL: The switching bus is experiencing stall for 3 seconds Jun 6 17:12:45 SAST: %ONLINE-SP-6-TIMER: Module 2, Proc. 0. Failed to bring online because of timer event Jun 6 17:12:45 SAST: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set off (Reset) Jun 6 17:12:45 SAST: %C6KERRDETECT-SP-2-SWBUSSTALL_RECOVERED: The switching bus stall is recovered and data traffic switching continues Jun 6 17:13:38 SAST: %ONLINE-SP-6-TIMER: Module 2, Proc. 0. Failed to bring online because of timer event Jun 6 17:13:38 SAST: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set off (Reset) Jun 6 17:13:38 SAST: SP: oir_disable_notice: slot2: lcp failed to go online After executing an 'power enable module 2', the module does come back online as indicated below, and all ports available / usable: Jun 6 19:26:57 SAST: %DIAG-SP-6-RUN_MINIMUM: Module 2: Running Minimum Online Diagnostics... Jun 6 19:27:10 SAST: %DIAG-SP-6-DIAG_OK: Module 2: Passed Online Diagnostics Jun 6 19:27:10 SAST: %OIR-SP-6-INSCARD: Card inserted in slot 2, interfaces are now online The 6506 is running IOS sup22-jk2sv-mx.121-26.E5. Software bug, or faulty hardware ?? Kind Regards, Chris. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
