Actually, it looks like the tech I had setup the mrtg config for this particular router had used the IP of one of the gig interfaces instead of the loopback interface. Changing it to use the loopback interface IP has it polling the correct data. It was running 64bit counters, but was just getting some bogus counters data using the interface IP. While I'm not sure why it would get the bogus counter data using that IP, it should have using the loopback IP in the first place.
Anyway, thank you everyone who replied. -Lee ---------- Forwarded message ---------- From: <[email protected]> Date: Wed, Jun 29, 2011 at 8:30 PM Subject: Re: [c-nsp] IOS-XR and MRTG interface counters not working To: Lee Starnes <[email protected]> What snmp version is mrtg using to poll your router? When near 100 megs or above you need to use at least snmp v2c or later and the 64 bit counters aka HC counters. ------Original Message------ From: Lee Starnes Sender: [email protected] To: cisco-nsp Subject: [c-nsp] IOS-XR and MRTG interface counters not working Sent: Jun 29, 2011 9:45 PM Hello, Has anyone had problems getting MRTG to pull counters from a 12410XR? We have it configured to poll interface counters and while the Gig interfaces have 80-100Mbps on them at all times, yet MRTG shows between 5.9bps and 7.2bps. Have not seen this on any of our IOS gear, so wondering if there is something different that has to be setup besides the snmp community to get this data. We are running XR version 4.0.1. Thanks, Lee. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ Sent via BlackBerry from T-Mobile _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
