Does it give you the option to set up the controller?
On Jul 26, 2011, at 6:41 PM, Joseph Mays wrote: > I have a T3/E3 card in a cisco 3640 that I want to use as a serialT3, but it > does not show up as a serial interface, nor is there even a controller line > in the config. It only shows up in the hardware infomration as a "Subrate > T3/E3 port". What does this mean? > > gw1.dist uptime is 1 hour, 36 minutes > System returned to ROM by power-on > System restarted at 17:00:56 EDT Tue Jul 26 2011 > System image file is "flash:c3640-is-mz.123-6.bin" > > cisco 3640 (R4700) processor (revision 0x00) with 124928K/6144K bytes of > memory. > Processor board ID 11876053 > R4700 CPU at 100MHz, Implementation 33, Rev 1.0 > Bridging software. > X.25 software, Version 3.0.0. > SuperLAT software (copyright 1990 by Meridian Technology Corp). > 2 FastEthernet/IEEE 802.3 interface(s) > 2 Serial network interface(s) > 1 Subrate T3/E3 ports(s) > DRAM configuration is 64 bits wide with parity disabled. > 125K bytes of non-volatile configuration memory. > 24576K bytes of processor board System flash (Read/Write) > > Configuration register is 0x2102 > > gw1.dist# > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
