Lukasz, it looks like the default value for keepalive packet is 10s. However, if I disconnect the other end from my switch port, the line protocol will be down immediately. How to explain this? In addition, there are interfaces, which by default don't have keepaive set(for example WS-C3750G-24TS SFP interfaces). They have "Keepalive not set" under "show interfaces" output. However, they still have "line protocol is up (connected)".. How to explain this?
regards, martin 2011/4/26 Lukasz Bromirski <[email protected]>: > On 2011-04-26 01:11, Martin T wrote: >> >> When Cisco switch or router port is "connected", it has status "line >> protocol is up". As far as I know, this applies to all interface >> types(10BASE-T, 100BASE-TX, 1000BASE-T, 1000BASE-LX10, 1000BASE-SX etc >> with different transceivers). >> What is this "line protocol"? I always thought "line protocol" is up >> once any electrical pulses are detected by Rx. Or is "line protocol" >> strictly "link integrity test"(LIT) pulses(100-200ns of electrical >> pulses with 16ms+/-8ms interval)? Any clarification would be much >> appreciated. > > "Line protocol" for Ethernet interfaces is Ethernet frame. Cisco boxes > send Ethernet keepalive frame and when it doesn't loop back, they > declare line protocol down: > > http://www.cisco.com/en/US/docs/ios/12_3/interface/command/reference/int_i1g.html#wp1154231 > > -- > "There's no sense in being precise when | Łukasz Bromirski > you don't know what you're talking | jid:[email protected] > about." John von Neumann | http://lukasz.bromirski.net > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
