It's very possible the fib is correct, but should be correctable by doing a "clear arp" and a "clear ip route *". What IOS are you running and what sup engine do you have? Also, what does "show ip cef exact-route source_ip dest_ip" show?
Are there anything else "interesting" configured? MPLS, PBR, i.e., what does the interface config look like? ---- Matthew Huff | 1 Manhattanville Rd Director of Operations | Purchase, NY 10577 OTA Management LLC | Phone: 914-460-4039 aim: matthewbhuff | Fax: 914-460-4139 -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Persio Pucci Sent: Thursday, July 28, 2011 3:23 PM To: [email protected] Subject: [c-nsp] 7600 HFIB bug? Hi all. I am new to the list and this is my first post. :) Trying to get to the bottom of a situation, sans-TAC. Long story short, for context sake, I had a 7300 that was replaced by a 7600 at my Rio de Janeiro site connecting to SP and NY. (SP --- RIO --- NY) Everything was working fine by the time we were finishing replacing the box, when our circuit to Sao Paulo was hit and stayed down for about 6 hours. When the circuit came back up, some communication to NY was just simply not working, the SP rotuer could not reach, for whatever reason, IP addresses that were reachable after replacing the box, before the hit. It used to work on a TE tunnel I had to remove and make Rio a BGP hop to put it to work while I tried to figure wtf was going on. Ever since, I can ping NY's IP address from Rio, but cannot from SP, altough all routing is in place (ISIS), all CEF entries are there. Well, after a few weeks working on this when time was allowed, I came to a intriguing situation today, while working with the help of a friend. I was trying to debug this by using a permit ACL with log-input on the Rio interfaces and see what was going on. When I applied the ACL on the interfaces (ip permit x x log-input, ip permit any any), things started working, and I was again able to ping from SP to NY. If I remove the ACL, I cease to ping NY from SP. I seems like something is borked at the 7600, cause the packets won't go through if they are CEF switched, but they will when they are punted to the CPU for the logging. Lookis like some FIB/HFIB issue that is beyond my comprehension. Any ideas besides going to TAC? Tks! _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
