Hi,
Have 2 100Mb eth ports in portchan, and 1 port seems to be doing all
the receiving:
sh interfaces fastEthernet 0/1
FastEthernet0/1 is up, line protocol is up (connected) Hardware is
Fast Ethernet, address is f4ac.c17d.af83 (bia f4ac.c17d.af83)
Description: FEC_TO_ESW01_P20
MTU 1998 bytes, BW 100000 Kbit, DLY 100 usec, reliability
255/255, txload 165/255, rxload 217/255
... 5 minute input rate 85322000 bits/sec, 13875 packets/sec
5 minute output rate 65048000 bits/sec, 12044 packets/sec
FastEthernet0/2 is up, line protocol is up (connected) Hardware is
Fast Ethernet, address is f4ac.c17d.af84 (bia f4ac.c17d.af84)
Description: FEC_TO_ESW01_P21
MTU 1998 bytes, BW 100000 Kbit, DLY 100 usec, reliability
255/255, txload 52/255, rxload 2/255
...
5 minute input rate 871000 bits/sec, 229 packets/sec
5 minute output rate 20396000 bits/sec, 3718 packets/sec
The portchan doesnt report any usage(reports packets/bytes etc just not
data rate or tx/rx)) for some reason on the 3560(the 2950 does though)
#sh int port-channel 2
Port-channel2 is up, line protocol is up (connected) Hardware is
EtherChannel, address is f4ac.c17d.af84 (bia f4ac.c17d.af84)
Description: FEC_TO_ESW01_BNE
MTU 1998 bytes, BW 200000 Kbit, DLY 100 usec, reliability
255/255, txload 1/255, rxload 0/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
Members in this channel: Fa0/1 Fa0/2 ARP type: ARPA, ARP Timeout
04:00:00
Last input 16:49:20, output 00:00:00, output hang never
Last clearing of "show interface" counters 16:31:53
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 670097
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
654778461 packets input, 542298725539 bytes, 0 no buffer
Received 576270 broadcasts (124103 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 124103 multicast, 0 pause input
0 input packets with dribble condition detected
1141651151 packets output, 665041631494 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
...
Any suggestions on how to balance the traffic better?
switches are 3560+2950
Thanks in advance.
-------------------------------------------------------------------------
This e-mail was sent via GCOMM WebMail http://www.gcomm.com.au/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
