Hello Dears, I need your help in Cisco CME setup, I have Voice FXO interface, on this interface I'm connecting PSTN line for normal phone calls.
after I did configure the telephony-service, dial-peer and the voice port, below are the configuration: telephony-service conference hardware no auto-reg-ephone max-ephones 20 max-dn 20 ip source-address 192.168.105.254 port 2000 timeouts transfer-recall 15 load 7911 SCCP11.8-4-2S.loads load 7960-7940 SCCP41.8-4-2S.loads load 7941 SCCP41.8-4-2S.loads load 7961 SCCP41.8-4-2S.loads time-zone 31 time-format 24 max-conferences 8 gain -6 moh moh-new.au multicast moh 239.0.0.1 port 2000 web admin system name ccmeu password ccmep dn-webedit time-webedit transfer-system full-consult secondary-dialtone 9 =============== dial-peer voice 1 pots destination-pattern 9T progress_ind setup enable 3 progress_ind alert enable 8 fax rate disable direct-inward-dial port 0/2/0 forward-digits all prefix 9 =========================== voice-port 0/2/0 groundstart auto-tip delay 10 caller-id enable ============================== voice-port 0/2/0 groundstart auto-tip delay 10 connection plar opx immediate 702 caller-id enable ============================== ephone-dn 2 dual-line number 702 name user2 ============================== ephone 2 device-security-mode none button 1:2 with the above configuration I'm not able to place any call through the PSTN line or to block international or mobile calls. the CME considering the prefix 9 as a digit of the call placed. I guess the problem is in the destination-pattern configuration, but unfortunately I didn't recognize the purpose of it, I need someone to help in this configuration. Thanks in Advance Ibrahim _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
