Hi All , Will VRF-LITE work for secondary ip address on an interface?
I have the following configuration for an internet router ,where in i have configured route leaking between VRF internet and global routing table , however the routing is working only for Primary ip address ip vrf internet ! interface GigabitEthernet0/0 description LATISYS_INTERFACE ip address 70.1.100.70 255.255.255.252 ip flow ingress ip flow egress duplex auto speed auto ! ! interface GigabitEthernet0/1 description INSIDE_INTER ip vrf forwarding internet ip address 205.78.181.1 255.255.255.0 secondary ip address 205.78.180.1 255.255.255.0 duplex auto speed auto ! ip route 205.78.180.0 255.255.255.0 GigabitEthernet0/1 ip route 205.78.181.0 255.255.255.0 GigabitEthernet0/1 ip route vrf internet 0.0.0.0 0.0.0.0 GigabitEthernet0/0 70.1.100.69 global Please find the ping output as below CR2911IGW.DEN#ping vrf internet 8.8.8.8 source 205.78.181.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds: Packet sent with a source address of 205.75.181.1 ..... Success rate is 0 percent (0/5) CR2911IGW.DEN#ping vrf internet 8.8.8.8 source 205.78.180.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds: Packet sent with a source address of 205.78.180.1 !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 32/35/36 ms Can someone please help me to find out what is wrong here . Thanks, Ranjith _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
