Hi Farooq,

I see this happening most of the time when I have a host, dual homed to 2 different switches for HA purposes , and the host link bonding/aggregation is configured to do load balancing instead of active/backup. Essentially its sending the traffic down both links, and switches learns the MAC address from directly connected host port and from port that is connected to the second switch.

check how link bonding is configured on the end host.

Anton


On 8/7/2011 10:14 AM, Farooq Razzaque wrote:

Hi All

I noticed the following messages with different timestamp on IPT SW01 
(connected to IPT servers - C2960G-24TC-L)



%SW_MATM-4-MACFLAP_NOTIF: Host 001c.f6e5.17b0 in vlan 119 is flapping between 
port Po1 and port Gi0/1

Here :

1) Gi0/1 is connected to Voice Gateway router

interface GigabitEthernet0/0 (Connected to IPT SW02 - Gi0/1)
  no ip address
  duplex auto
  speed auto
  media-type rj45
  bridge-group 1
!
interface GigabitEthernet0/1  (Connected to IPT SW01 - Gi0/1)
  no ip address
  duplex auto
  speed auto
  media-type rj45
  bridge-group 1

interface BVI1
  ip address xxxxx
  ntp broadcast client
  ntp broadcast
  h323-gateway voip interface
  h323-gateway voip bind srcaddr xxxxx

2) Mac-address 001c.f6e5.17b0 is the address of interface Gi0/0 of Voice 
Gateway Router and same address for BVI1

GigabitEthernet0/0 is up, line protocol is up
   Hardware is BCM1125 Internal MAC, address is 001c.f6e5.17b0 (bia 
001c.f6e5.17b0)

GigabitEthernet0/1 is up, line protocol is up
   Hardware is BCM1125 Internal MAC, address is 001c.f6e5.17b1 (bia 
001c.f6e5.17b1)

BVI1 is up, line protocol is up
   Hardware is BVI, address is 001c.f6e5.17b0 (bia 001c.f6e5.17b0)

3) Po1 is the port channel on IPT SW01 (Gi0/22 and Gi0/23) and Core switch (VSS)


interface GigabitEthernet0/22
description ++++ L2 Trunk to Coreswitch ++++
  switchport trunk native vlan 999
  switchport trunk allowed vlan 119
  switchport mode trunk
  logging event trunk-status
  logging event bundle-status
  channel-protocol lacp
  channel-group 1 mode active
!
interface GigabitEthernet0/23
description ++++ L2 Trunk to Coreswitch ++++
  switchport trunk native vlan 999
  switchport trunk allowed vlan 119
  switchport mode trunk
  logging event trunk-status
  logging event bundle-status
  channel-protocol lacp
  channel-group 1 mode active

Appreciate your help
                                        
_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/


_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

Reply via email to