I am currently working on replacing two 7200's and a 3750 switch with an ASR9000 Router for a 10G upgrade. Currently the 3750 is only preforming layer2 functions and the two routers connect to it via 802.1q trunks. The switch then hands off a 802.1q trunk to other downstream switches. I am unsure of how to configure the ports on the ASR to allow me to put more than one port in a vlan. I have tried going through the different configuration guides and think that either the would do something like the l2vpn set or the IRB setup listed in the "Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide". If I were using a 6500 or 7600 I know how I would set up the ports, however I am unsure how I would do it in the ASR. I am wondering about the best way to set this up, or if I really shouldn't be using the 40 Port linecard for switching/layer2 functions. Thanks for any input and I'd really appreciate any configuration snippets.
--- Brian Raaen Zcorum Network Architect [email protected] _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
