I want to thank everyone for their assistance, I think I have a working config, however I am having issues locating a working SFP (it keeps denying the PID of everthing I have). If anyone has had an SFP module that worked for them I would appreciate the input. After I am able to test I'll post the config snippit.
On Wed, Dec 21, 2011 at 3:43 PM, Brian Christopher Raaen <[email protected]> wrote: > I am currently working on replacing two 7200's and a 3750 switch with > an ASR9000 Router for a 10G upgrade. Currently the 3750 is only > preforming layer2 functions and the two routers connect to it via > 802.1q trunks. The switch then hands off a 802.1q trunk to other > downstream switches. I am unsure of how to configure the ports on the > ASR to allow me to put more than one port in a vlan. I have tried > going through the different configuration guides and think that either > the would do something like the l2vpn set or the IRB setup listed in > the "Cisco ASR 9000 Series Aggregation Services Router Interface and > Hardware Component Configuration Guide". If I were using a 6500 or > 7600 I know how I would set up the ports, however I am unsure how I > would do it in the ASR. I am wondering about the best way to set this > up, or if I really shouldn't be using the 40 Port linecard for > switching/layer2 functions. Thanks for any input and I'd really > appreciate any configuration snippets. > > --- > Brian Raaen > Zcorum > Network Architect > [email protected] _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
