Given that it's "only" a SUP-2 wouldn't it just be easier to obtain a 2nd hand one (eg. ebay) for a few hundred, rather than mess around trying to replace/solder NVRAM on an existing one ?
Of course this is assuming it is a hardware issue, but again, a replacement one will tell you fairly quickly if this is the case and also give you a spare if it's NOT the problem. regards, Tony. ________________________________ From: Xu Hu <[email protected]> To: Ambedkar <[email protected]> Cc: "[email protected]" <[email protected]> Sent: Tuesday, 3 April 2012 1:21 AM Subject: Re: [c-nsp] Cisco 6509 sup2 NVRAM corrupted.. First make sure it is a hardware problem or other issues. After manual boot, dir nvram to check whether the hardware can recognise or not. If can, maybe it is a bug. If cannot, pull out the card, change a new one. Since I also donn't know how to change the hardware, cannot give you a better idea. Thanks and regards, Xu Hu On 2 Apr, 2012, at 16:07, Ambedkar <[email protected]> wrote: > Hi, > I am having a Cisco 6509 sup-2 switch which is booting properly. When i > diagnose it says NVRAM area is corrupted and initializing to default > values. Every time i need to boot manually. > > Any solution regarding the NVRAM. > > Where can i find the NVRAM on the supervisor board, is there any chance to > replace with new NVRAM memory. > > Thanks > Bye > Ambi. > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
