Hi There,
A quick questions in relation to the following policy based routing
configuration for a Cisco 6500.
Example:
interface TenGigabitEthernet9/8
ip address 10.10.10.10 255.255.255.252
no ip redirects
ip directed-broadcast
ip route-cache flow
ip policy route-map MY-TEST
!
route-map MY-TEST permit 10
match ip address MY-TEST-ACL
set ip next-hop 192.168.255.10
set ip df 0
!
route-map MY-TEST permit 20
1/ Does having the permit 20 rule cause all my packets to be punted to the
CPU???
According to the output below, I believe this is happening as a result of
the permit 20 rule.
#show tcam interface tenGigabitEthernet 9/8 acl in ip
* Global Defaults shared
Entries from Bank 0
Entries from Bank 1
permit ip any 224.0.0.0 15.255.255.255
punt ip any any
2/ If point one is true, can I just remove the permit 20 rule which I
believe will stop all packets being punted to the CPU?
I don't believe policy-maps have an implicit deny at the end, so packets
that don't match permit 10 should continue to be routed using the routing
table. Is this true also?
Thanks.
Andy
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
