According to this doc you can set the switch to use dst mac, src mac, or a combination of the two on the 3560.
http://www.cisco.com/en/US/tech/tk389/tk213/technologies_tech_note09186a0080094714.shtml On May 28, 2012, at 10:38 AM, Mike <[email protected]> wrote: > Hello, > > I have 2 3560's that have dual links between them. Each link is 100mbps > and I want to aggregate the bandwidth and have failover as well. From my > read, most link aggregation will use mac addresses to hash and determine > which port to forward thru. I belive however I have the worst case scenario > since traffic IN will have 1500 different source macs but 1 destination, and > traffic OUT will have 1 source mac and 1500 destination macs. Even worse, > this traffic is PPPoE and not IP, eliminating any sort of ip based selection > criteria. This means, to my read anyways, I would have course grained load > sharing in 1 direction, sort of defeating the point here. I was wondering if > anyone had any ideas for this platform and suggestions how I might get better > performance in this situation. > > Thanks. > > Mike- > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
