Thanks Oil, my GSR used IOS, that's why cannot check the interface of Standby RP.
2012/6/5 Oliver Boehmer (oboehmer) <[email protected]> > > > My GSR have two PRP2, each PRP has three management interface which > can be > > configured IP address. > > But the thing is through show ip interface brief, i just can see three > > Ethernet interface, cannot see six Ethernet. > > Now my issue is if i configure the E0 interface as ip address > > 192.168.1.1/24, > > when the active PRP down, will the configuration change to the standby > PRP? > > In IOS, the ports on the standby PRP will be inactive, there is no IP > address configured on them, hence you only see the ports from the active > RP, and when the standby takes over as active, it will (obviously) use > the same addresses. > > This is different from IOS-XR where the standby ports are visible and > active, and which require an IP address, using the virtual-address as a > mechanism to reach the management-interface by the same address, no > matter which RP is active. > > oli > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
