δΊ 2012/8/26 23:43, Peter Rathlev ει:
On Sun, 2012-08-26 at 17:42 +0800, zhangyongshun wrote:
hi,everybody:
I have add two line command for my FWSW PAT configure.
nat (inside) 100 129.1.1.0 255.255.255.0
global (outside) 100 122.226.204.41
but,now i can't remove this command from FWSW running-configure.
...
JH-DYGS-FWSM(config)# no nat (inside) 100 ?
configure mode commands/options:
access-list Specify access-list name after this keyword
FWSM(config)#
Just ignore the "?"-hints and issue
no nat (inside) 100 129.1.1.0 255.255.255.0
Works fine for me.
Yes,It works fine.
another question:
nat (inside) 18 0.0.0.0 0.0.0.0
if this commmand match any real inside network traffic?
That would depend on the definition of "any real inside network
traffic". The NAT statements matches all IPv4 traffic that is not
matched by something more specific, like narrower NAT statements or
statics.
I want to make sure if this ACL match any outbound traffic from inside
interface.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
