It has to be there -though I don't have XE box up to check. The MPLS Traffic Engineering-LSP Attributes section mentions the functionality in XE:
Tunnel Attributes and LSP Attributes Cisco IOS XE tunneling interfaces have many parameters associated with MPLS TE. Typically, you configure these parameters with tunnel mpls traffic-eng commands in interface configuration mode. Many of these commands determine tunnel-specific properties, such as the load-sharing factor for the tunnel. These commands configure parameters that are unrelated to the particular LSP in use by the tunnel. However, some of the tunneling parameters apply to the LSP that the tunnel uses. You can configure the LSP-specific properties using an LSP Attribute list. adam -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Alessandro Braga Sent: Friday, September 28, 2012 9:51 PM To: cisco-nsp Subject: [c-nsp] ASR1K - MPLS-TE Load-Balancing/Load-Share (IOS-XE) Hello Experts, I'm trying to figure out a MPLS-TE Load-Balancing/Load-Share configuration on an ASR1K hardware running IOS-XE 12.1(33) software or 15.1-S3. Can you help me to know if are there any special configuration unlike IOS patterns? Does we have any like this in IOS-XE ? < tunnel mpls traffic-eng load-share > I didn't found at the doc-cd. P.S: at this time I have not a terminal access. BR, -- Alessandro Braga CCIE #30939 _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
