Without further information, at least a topology, switch models, and traffic information, you aren't going to get much feedback short of generalities. So here goes.
Buffer overflows may be solved in general by two main methodologies: 1) buffer management - Ensure that what limited buffers you are have allocated in the most efficient way. If you have QoS on, some switches default config can dedicate bufferes to largely unused or underused queues. Or turn off QoS entirely. If you must have QoS turned on, and you must throw traffic away, try to throw away traffic you care less about. 2) traffic management - Consider the effects of mis-matched interface speeds within your network. Consider the impact of oversubscription of uplink and access ports. That is, reduce buffer use by adding capacity to drain queues before the fill. -e On Tue, Oct 30, 2012 at 9:01 AM, Righa Shake <[email protected]> wrote: > Hi , > > I would like to get to understand how I can solve a problem of buffer > overflows during microbursts on a 2960 Cisco Switch. > > > Any assistance would be highly appreciated. > > > Regards, > Righa Shake > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
