hello guys i wanna connect a modem to a 2800 router by AUX port. this is my configuration: modem InOut modem autoconfigure discovery transport input all stopbits 1 speed 38400 flowcontrol hardware
the speed value changes because "mode autoconfigure discovery" is set. i used blue console cable RJ45 to DB9 for connecting AUX port to modem. this is the output of "show line 1" command: Tty Line Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int 1 1 AUX 9600/9600 - inout - - - 4 0 0/0 - Idle Line 1, Location: "", Type: "" Length: 24 lines, Width: 80 columns Baud rate (TX/RX) is 9600/9600, no parity, 1 stopbits, 8 databits Status: No Exit Banner, Modem Speed Locked, Modem Signals Polled Capabilities: Hardware Flowcontrol In, Hardware Flowcontrol Out Modem Callout, Modem RI is CD, Modem Discovery *Modem state: Idle* *Modem hardware state: noCTS noDSR DTR RTS* TTY NUMBER 1 i read when the connection is correct, modem hardware stats should be CTS not noCTS. moreover i can not do reverse telnet to modem. please let me know how i should fix it and configure my modem by AT commands. thanks SAM _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
