The main issue would be that a single L2TP tunnel would hash to a single uplink, and would never load share across different uplinks.
What you most likely would have to do is to have multiple IP addresses on the LAC and LNS (loopbacks...), and route them through different links. The LAC can loadshare the sessions between different L2TP tunnels... Arie -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Warwick Duncan Sent: Wednesday, November 28, 2012 11:55 To: [email protected] Subject: [c-nsp] LAC for PPPoE with multiple links to LNS Hi We're planning a network of a couple of thousand remote sites connecting with PPP to a central router (we're thinking a Cisco ASR 1002-X). For most sites we can get ethernet to the central router and can use PPPoE but for several hundred we have to go via a third party's layer 3 network, where the layout could be as follows: Site 1 -- -- layer 3 upstream -\ Site 2 -- Aggregation point (LAC) -- layer 3 upstream -- ASR (LNS) Site 3 -- -- layer 3 upstream -/ i.e. we connect a handful of sites (between 2 and 20) with ethernet to a central point at which we buy multiple layer 3 upstream links, all from the same provider, to give the required bandwidth. For reasons beyond our control, a single link can't provide adequate bandwidth for even a single site. The obvious starting point, unless we're missing something, is to put an L2TP LAC at the aggregation point and tunnel the PPP to the central ASR, which we configure as an LNS. This achieves our goal of having a PPP session between the ASR and each site. How do we elegantly aggregate the multiple layer 3 links between LAC and LNS into a single logical bundle? If it can't be elegant, what's the least ugly way to do it? I don't think multilink PPP is applicable in this scenario (it would be between Site N and LAC, had the multiple links been there) but I'd happily be proved wrong. It would be nice to guard against equipment failure at the aggregation point. Is there a way to put up 2 LAC's with the upstream links split between them, yet still provide any single site with the full aggregated bandwidth of all upstream links? Lastly, would something like a 3640 be an adequate LAC for, say, 12Mbps upstream (6 x 2Mbps serial links)? Are there any gotchas with doing MPLS over PPP on an ASR 1002-X? Thanks for reading this far... Regards Warwick -- Warwick Duncan Frogfoot Networks ISP http://www.frogfoot.com/ +27.21.448.7225 _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
