--- On Sun, 12/16/12, Nick Hilliard <[email protected]> wrote:
> From: Nick Hilliard <[email protected]> > Subject: Re: [c-nsp] Moving Routing from 7206VRX to 6509-E > To: "An Nguyen" <[email protected]> > Cc: "[email protected]" <[email protected]> > Date: Sunday, December 16, 2012, 1:42 PM > On 16/12/2012 21:32, An Nguyen > wrote: > > Would someone please tell me what the commands are to > setup a Layer 3 > > EtherChannel (LACP preferred) for the 4 ports of the > 10-GB switch modules > > on the chassis, and then create several sub-interfaces > within this > > EtherChannel? > > interface range ten 1/1-4 > no switchport > channel-group 1 mode active > channel-protocol lacp > > interface po1 > no shutdown > > interface po1.555 > encapsulation dot1Q 555 > ip address 192.0.2.1 255.255.255.0 > interface po1.556 > encapsulation dot1Q 556 > ip address 192.168.0.1 255.255.255.0 > > etc. > > Like others on this channel, I would suggest getting a > consultant to handle > this for you. > > Nick I have to concur. For this platform-migration, it would probably be best to bring in a Consultant. It also may be worthwhile for your $Employer to consider some form of *service-contract* with Cisco. CCO has a wealth of information (for your own edification). You will need a valid-contract to have access to said info! Google-Foo will only get you so-far. ./Randy _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
