27.02.2013 10:47, Aivars пишет:
I admit that it would be "cleaner" to configure a bit smaller MTU on
interface PW-Ether555 but it does not effect PW MTU itself.
As you can see from the initial post show l2vpn xconnect neighbor ...
detail command, MTU is equal on local and remote. IOS-XR does a really
good job on this show ... detail.
ok. Thanks to all for explanation!
Aivars
"mtu" on IOX is L2, IOS treats it as packet mtu.
--
Christian
On 27.02.2013, at 07:49, Artyom Viklenko <[email protected]> wrote:
26.02.2013 08:13, Aivars ?????:
interface PW-Ether555
mtu 9216
[...]
7600:
interface TenGigabitEthernet3/4.555
encapsulation dot1Q 555
xconnect 192.168.0.2 555 encapsulation mpls
mtu 9202
Hi! I'm not sure about ASR9K, but is it ok that you have different MTU
on opposite side? Between two 7600-s VC didn't come up if MTU mismatch.
--
Sincerely yours,
Artyom Viklenko.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
--
Sincerely yours,
Artyom Viklenko.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
