Hi, I have 3 interfaces on my 2911, out of which gig0/0 is used for outside, gig0/1 is used as a inside and gig0/2 is used for management & nms alert.
Now i have done the dynamic nat on gig0/1 with outside interface which is working fine. Now i have a requirement to do the ping on WAN ip of my next hop on inside interface gig0/1 from NMS which are lies in gig0/2. MY inside connecting router is maintained by some one else and has allowed only 8 ip's (10.14.29.8/29) through which i can access, now i want to use one of the ip so that i can NAT my nms ip (172.31.4.22) so that the nms can ping my other router wan ip (10.25.17.9) on inside network. Can any body tell me the static NAT config. Following is the config:-- interface GigabitEthernet0/0 ip address 172.25.20.20 255.255.255.248 ip nat outside ip virtual-reassembly in duplex auto speed auto ! interface GigabitEthernet0/1 ip address 10.25.17.12 255.255.255.248 ip nat inside ip virtual-reassembly in duplex full speed 100 ! interface GigabitEthernet0/2 ip address 172.31.9.70 255.255.255.0 duplex auto speed 1000 ! interface FastEthernet0/0/0 no ip address ! interface FastEthernet0/0/1 no ip address ! interface FastEthernet0/0/2 no ip address ! interface FastEthernet0/0/3 no ip address ! interface Vlan1 no ip address ! ip forward-protocol nd ! no ip http server no ip http secure-server ! ip nat inside source route-map nonat interface GigabitEthernet0/0 overload ip route 0.0.0.0 0.0.0.0 10.25.17.9 ip route 10.14.29.9 255.255.255.255 172.25.20.17 ip route 10.14.29.10 255.255.255.255 172.25.20.17 ip route 172.31.4.22 255.255.255.255 172.31.9.1 ! access-list 110 permit ip any host 10.14.29.9 access-list 110 permit ip any host 10.14.29.10 ! route-map nonat permit 10 match ip address 110 Regards Daljit Singh _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
